A bottle wall thickness tolerance on a specification drawing is only usable if it names the zone, the method and the limit the parties have agreed. A single band written next to a mid-body view does not automatically cover the shoulder, the heel or the base.
What the drawing should name
Write the zone in words that the inspector can find on the bottle, such as shoulder, mid-body, heel, push-up or pinch-off. If more than one point is required around the circumference, say so.
Name the method in enough detail that two laboratories will not use different tools without noticing. A cut-section micrometer and a non-destructive Hall-effect gauge are not the same method unless the drawing, or an agreed procedure, says how they are to be compared.
State whether the limit is a minimum in that zone, a range, or both, and whether it applies to every cavity. Industry voluntary methods for plastic containers treat test locations as a matter for the container design and for the specification agreed between the parties.
This page is about how to write that tolerance. It is not a materials or process guide, and it does not quote a typical tolerance, because we do not have a verified public figure that fits bottles in general.
Why one mid-body tolerance is not enough
The wall is rarely even from finish to base. A mid-body band can pass while a heel or a shoulder is already outside what the design can stand.
If the drawing shows only one thickness, inspectors will measure the easiest point. Add the risk zones that the design actually depends on, especially if lightweighting or a new mould is planned.
For what to write on the daily form once the drawing is agreed, see the wall thickness inspection record. Incoming lots against a supplier drawing are covered in incoming bottle wall thickness inspection.
Want to see how a marked zone is measured against a drawing? Tell us what you need to test. We test a similar material sample and send you the video, so you do not need to ship a sample. If you prefer to send your own, we accept that too.
Measuring in the way the drawing intends
A Hall-effect thickness gauge reads the wall without cutting the bottle, which is useful when the drawing asks for a non-destructive check, or when the bottle must be retained. A steel target ball sits inside, and a probe touches the outside.
Our Hall-effect bottle wall thickness gauge is built for non-destructive wall and base checks on non-magnetic plastics and glass. The measuring steps are in how to measure bottle wall thickness. Use the marks the drawing names, not a substitute point.
If the drawing is silent on the method, agree one with the other party and add it to the specification or the procedure. Please confirm with us if you want help describing a non-destructive check for a named zone. We will not invent a tolerance value.
Changing the drawing when the design changes
When the bottle is lightened, or the mould or resin changes, review the zones and the limits. A tolerance written for a heavier design may not protect a thinner heel.
Keep process notes off the drawing if they will go stale, and keep them in the work instruction instead. The drawing should still say where to measure and what the agreed limit is.
Frequently asked questions
Can I write one wall-thickness tolerance for the whole bottle?
You can, but it is a weak drawing if the shoulder, heel or base can run thinner than mid-body. Name the zones that matter.
Should the drawing specify the measuring method?
Yes, or the accompanying procedure should. Otherwise two sites may cut sections in one place and use a non-destructive gauge in another, and then disagree.
Will this page give a typical tolerance to copy onto a drawing?
No. The limit has to come from the design and from the parties who own the specification. Please confirm a wording with us if you need help, but not a generic number.
Get a test video for your bottles
Tell us what you need to test, such as the material, the size and the test method. We test a similar material sample on the instrument you are looking at and send you the video, so you do not need to ship a sample. If you prefer to send your own, we accept that too.
Questions about a model or a test? Email Amy Zhao, Export Manager, at info@halleffectthicknessgauge.com.