Multilayer bottle wall thickness has two parts: the whole wall, and the thin barrier and tie layers inside it. A bottle can look fine on the first and still fall short on the second, so quality teams usually plan separate checks for each.
What a multilayer bottle wall is made of
Coextruded bottles combine several materials in one wall. Each material comes from its own extruder, and the layer ratio is set by the extruder speeds before the streams join into one parison.
Typical structures pair a polyolefin body with a barrier layer of EVOH or polyamide, bonded by thin tie layers. Machine builders list such walls for agrochemical bottles, chemical cans, sauces, and cosmetic creams that need protection for actives and fragrance.
The barrier layer is usually a small fraction of the wall. It is thin, yet it carries much of the protection against oxygen, solvent or aroma loss.
Why total wall thickness alone is not enough
Voluntary methods for plastic containers link wall thickness consistency to permeation, oxygen ingress and water vapour loss. On a single-material bottle, the wall map covers most of that story.
On a multilayer bottle it does not. Blow moulding suppliers note that an acceptable total wall does not mean the barrier, recycled or virgin layer is distributed correctly, so the layer ratio should be checked at critical sections.
The zones that thin out on any blow moulded bottle, such as corners, heel, handle and pinch-off, are also where a barrier layer can stretch thin.
Questions about a model or a test? Email Amy Zhao, Export Manager, at info@halleffectthicknessgauge.com.
How laboratories check individual layers
The standard laboratory route is a cross-section. Analysts slice a thin section with a microtome, look at it under an optical microscope and measure each layer.
Staining helps. Iodine colours polar materials such as EVOH and polyamide, which makes the barrier layer easy to pick out. Thermal analysis and infrared spectroscopy can then identify the polymer in each layer.
Pharmaceutical packaging studies use the same approach to confirm that the barrier layer is present and to map its thickness at the body, corners and seam. These methods cut the bottle, so they are usually run on a planned sample rather than every unit.
Where a wall thickness gauge fits on multilayer bottles
A non-destructive wall gauge is useful for mapping where a bottle is thick or thin without cutting it. That map tells you which zones deserve a cross-section.
What a Hall-effect reading represents on a layered wall, and whether a barrier layer affects it, is a point we confirm for each structure before you rely on it. Contact us with your layer structure and the zones you check.
Our Hall-effect bottle wall thickness gauge is built for non-destructive wall and base checks on non-magnetic plastics and glass.
For how Hall-effect, ultrasonic and contact gauges differ in general, see Hall-effect vs ultrasonic gauges.
Building a check plan for coextruded bottles
Mark the same zones on every bottle, based on the design and the specifications agreed with your supplier or customer. Voluntary methods for plastic containers set test locations this way.
Map the whole wall on a regular basis to watch the distribution. Then cut planned samples at the zones that matter, usually corners, heel, handle and pinch-off, to confirm the barrier layer.
Keep the layer results and the wall map side by side for each lot and cavity. When a barrier problem appears, the two records together show whether the cause is overall wall or layer ratio.
Frequently asked questions
Which layer in a coextruded bottle is usually the thinnest?
The barrier and tie layers. They are a small part of the wall, which is why they are checked by cross-section under a microscope.
Does a multilayer bottle need a different wall thickness limit?
The limits come from the parties who own the bottle specification. If the barrier matters for your product, agree its check separately, because an acceptable total wall does not settle it.
Talk to our factory team
We sell direct from our factory, so you work directly with our factory team. Questions about a model or a test? Email Amy Zhao, Export Manager, at info@halleffectthicknessgauge.com.